Introduction; Parts & Assembly - Nostalgia Products MDF200 Instrucciones Y Recetas

INTRODUCTION

Thank you for purchasing the AUTOMATIC MINI DONUT FACTORY™ from Nostalgia™!
Now you can cook hot and tasty mini donuts in your own kitchen! Your family
and friends will enjoy watching the donuts form, cook and travel down the
donut slide. Have fun and enjoy your AUTOMATIC MINI DONUT FACTORY™!
Fresh mini donuts are perfect for:
• Breakfast or Brunch
• Bake Sales
• Dessert
• Party Treats
PARTS & ASSEMBLY
ASSEMBLY
Your AUTOMATIC MINI DONUT FACTORY™ comes fully assembled when
removed from the box. The Donut Bin, Drainage Tray, Power Cord
and Measuring Cup, will be the only loose parts included.
Prepare for first use by thoroughly washing the Dough Dispenser, Donut Slide,
Donut Bin and Drainage Tray in warm, sudsy water and dry thoroughly. DO
NOT put the Base in water. To clean the Base when needed, use a damp cloth
to wipe the exterior, and then dry off with a clean, non-abrasive towel.
Follow these steps to remove parts for cleaning:
1. Unlatch and rotate the motor dispenser head counter clockwise, exposing
the Dough Dispenser. Remove the Dough Dispenser for washing by
lifting up and out of the notched receptor hole it sits in.
2. Remove the Donut Slide located on end of the AUTOMATIC MINI DONUT
FACTORY™ for washing. To remove the Donut Slide, place thumb and first
finger on either side of the slide and pull out and away from the unit.
5