Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Guide
Wallplate installation
1. Separate wallplate from thermostat.
2. Mount wallplate as shown below.
Drill 3/16" holes for drywall.
Drill 7/32" holes for plaster.
Wall anchors
Must be installed by a trained, experienced technician
• Read these instructions carefully. Failure to follow these instructions
can damage the product or cause a hazardous condition.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
69-2668ES—05
Grasp top and bottom of wallplate
and pull to remove from thermostat.
Wire hole
2
M28073
Mounting screws
MCR31514
Publicidad
Tabla de contenido
