Vetus BTKIT Instrucciones De Instalación Y Manual Del Propietario página 11

• Fit the inspection cover in the tank using the gasket supplied.
• Screw the cover tight against the backing ring using the screws
supplied.
• Assemble the fittings (A) and the suction tube (B) with the gas-
ket rings supplied. Tighten the nuts using the wrench, never with
water-pump pliers. Do not tighten the nuts excessively.
• Consult the diagrams on the next page for installation of the
exhaust pipe.
• After 2 days check that the connector nuts are still tight, tighten
more securely if required. Repeat this after 4 days.
• To prevent blockages caused by hairs and coarse waste in parti-
cular, all fittings should have burrs removed internally, local nar-
rowing should be reduced to a minimum and any changes in pipe
diameter should be done using conical adapters or large radii.
• Fit the sender for a waste water level meter, if fitted
B
O-ring
ø 57 mm
(2 1 / ")
4
1
O-ring
2 3
Connection kit for waste water tanks
O-ring
4
A
O-ring
O-ring
O-ring
5
ENGLISH
ø 43 mm (1 11 / ˝)
16
O-ring
15˚
6
11
110105.04