Blade Replacement; Maintenance; Replacing The Battery; Cleaning The Mower - Poulan Pro PPB4020M Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BLADE REPLACEMENT

WARNING:
by wearing heavy gloves and/or wrapping the
cutting edges with rags or other materials when
performing any maintenance on the blades.
ALWAYS remove battery when servicing or
transporting the mower.
NOTE: Only use authorized replacement
blades.
• Stop the motor. Allow blade to come to a
complete stop.
• Remove the battery pack.
• Turn the mower on its side.
• Wedge a block of wood between the blade
and mower deck to prevent the blade from
turning.
• For the BLADE I, loosen the blade nut by
turning it counterclockwise (as viewed from
bottom of mower) using a 15 mm wrench
or socket (not provided). For the BLADE II,
loosen the blade nut by turning it clockwise
(as viewed from bottom of mower) using a
15 mm wrench or socket (not provided).
• Remove the blade nut, spacer, blade
insulator, and blade.
• Make certain the motor assembly is pushed
completely against the motor shaft.
• Place the new blade on the shaft against
the motor assembly (3). Ensure blade is
properly seated with shaft going through
center blade hole and the two blade posts
(4) inserted into their respective holes on
the blade. Make sure it is installed with the
curved ends pointing up toward the mower
deck and not down toward the ground.
When seated properly, the blade should
be flat against the motor assembly. Install
the blade insulator (5) and spacer (6), then
thread the blade nut (7) on the shaft and
finger tighten.
Tighten

MAINTENANCE

Always protect your hands
Loosen
Tighten
Loosen
2
5
6
7
NOTE: Make certain all parts are replaced in
the exact order in which they were removed.
• For the BLADE I, torque the blade nut
down clockwise using a torque wrench (not
provided) to ensure the bolt is properly
tightened. For the BLADE II, torque the
blade nut down counterclockwise using a
torque wrench (not provided) to ensure the
bolt is properly tightened. The recommended
torque for the blade nut is 30-35NM.

REPLACING THE BATTERY

The mower battery is designed for maximum
life; however, like all batteries, it will eventually
need to be replaced.
Charge the new battery pack before use.
To install a new battery:
• Carefully unlock and remove the battery
pack.
• Install the new battery pack.
1
• Take the old battery pack to a recycling
center that accepts lead acid/lithium ion
batteries. Never dispose of battery in fire or
regular household trash.

CLEANING THE MOWER

2
WARNING:
of electric shock, do not expose the mower
to water. The underside of the mower deck
should be cleaned after each use, because
grass clippings, leaves, dirt, and other debris
14
5
6
7
In order to reduce the risk
3
4
1

Publicidad

Tabla de contenido
loading

Tabla de contenido