BEARWARE 303717/20200115HK016 Manual página 31

Channel display
The weather station receives the signal of the outdoor sensor automatically. You
can switch between the different channels using the "CHANNEL/+" button. Select
the same channel, which you select for the outdoor sensor. The channels of the
outdoor sensor can be selected on the device directly using a toggle switch.
Receiving the outdoor sensor signal
The outdoor sensor sends a signal twice a minute, which is automatically received
by the base station. You can also manually enable the signal reception. To do this,
press the "Sensor" button on the back of the device until the connection icon
starts flashing. Once the signal has been successfully received, the symbol stops
flashing and the received temperature and humidity are shown on the display of
the weather station.
Frost icon
When the temperature falls below the 3°C mark in the outdoor display, the
display shows a "
8. Advanced settings
Determining the relative air pressure
You have the option to adjust the relative air pressure according to the weather
report for your current location. To do this, press and hold for the "BARO" button
for about 2 seconds until "ABS" or "REL" flashes on the barometer display.
Navigate to the relative (REL) air pressure using the "CHANNEL / +" and "MEM / -"
buttons and confirm with the "BARO" button.
The air pressure value starts flashing now. You can adjust it using the "CHANNEL
/ + " and "MEM / -" buttons. Confirm and save your setting using the "BARO"
button.
Temperature trend
The temperature trend shows the possible weather changes as a trend.
indicates "rising"
indicates "constant"
indicates "falling"
English
" symbol.
31