Krups XP 1020 Modo De Empleo página 12

notice KRUPS XP1020-0828035.qxd:-0828035
MAKING CAFFE LATTES
I
Follow the instructions for "Making Cappuccinos" with the following proportions: 2/3 frothy milk,
1/3 espresso, and if desired you may spoon some milk foam on top.
STEAMING WITHOUT MAKING ESPRESSO
Steam is used to froth milk and also to reheat water (tea, hot drinks).
I
Check that the appliance is unplugged and that there is no contained pressure. (See CAUTION-
PRESSURE)
I
Measure out a small amount of water and pour into tank. For example: 2 oz (50 ml) of liquid to heat
4 oz (100 ml) of liquid.
Important: for maximum efficiency, avoid putting more than 4 oz (100 ml) of water into the
tank.
I
The ON/OFF pilot light will light up.
I
Steam is produced after 2 to 3 minutes preheating.
I
Once the liquid is hot, turn selector knob back to "Off" (b1) and unplug the appliance.
If you do not need all the water for steaming, proceed as follows:
I
Turn off the machine.
I
Release the remaining steam pressure into another container.
I
Before turning the knob again, turn the knob to "steam" (b3) to remove any steam, take care to put a
cup underneath the steam nozzle.
CAUTION !
Do not turn the selector knob back to "Off" (b1) before all steam is released! (See CAUTION
- PRESSURE)
18/04/08
I
Tightly screw on the boiler cap.
I
Plug in the appliance.
I
Immerse the steam nozzle in the liquid to be heated.
I
Turn the knob to "steam".
14:59 Page 11
English
11