Cleaning And Servicing; Decalcifying The Espresso Side - Krups XP 1020 Modo De Empleo

notice KRUPS XP1020-0828035.qxd:-0828035
English
ATTENTION!
The plastic housing of the cappuccino nozzle (g) has 2 fine holes at the top which draw air into the milk.
If those holes get clogged, the milk will not be frothed properly. Therefore, do not dip the cappuccino
nozzle in milk or froth up to those holes.
ATTENTION!
Immediately after use, wash the steam nozzle with a moist sponge.

CLEANING AND SERVICING

CLEANING THE CAPPUCCINO NOZZLE
Clean the steam nozzle each time after you have immersed it in the milk, otherwise the inside of the
nozzle becomes clogged and the milk deposits on the outside harden and become difficult to remove.
I
If clogging does occur, remove the plastic housing of the cappuccino nozzle (g) once appliance is cold
and then unscrew the tip of the steam nozzle.
Remove all milk particles using a sewing needle and rinse under the faucet. Replace nozzle tip making
sure to screw it on tightly. Wipe off the outside of the nozzle with a wet cloth. The plastic housing of
the cappuccino nozzle should be rinsed in warm water. If the small suction openings are clogged up,
they can be opened with a small needle.
CAUTION !
Do not try to open or disassemble the main body of the machine.

DECALCIFYING THE ESPRESSO SIDE

The warranty does not cover faulty or broken espresso machine due to not being descaled.
I
Due to the acidity of the cleaning solution, we recommend protecting your worktop and sink during
the descaling process, especially if it is made of marble or stone. Isolate your appliance with a tea
towel, a tablecloth or a tray that you do not require.
The espresso machine must be decalcified regularly. The frequency depends on the hardness of your
water and how often you use the espresso machine.
Before descaling, the brewing sieve on the brewing head must first be screwed off.
1. Remove all lime and coffee residues from the brewing sieve and the brewing head.
2. Remove the plastic housing of the cappuccino nozzle (g).
As a descaling agent we recommend the use of Krups descaling solution N°F054 available at authorized
Krups retailers and Service Centres or by contacting your respective countries Customer Service
Department.
12
18/04/08
I
Unplug the appliance and let it cool down completely before you clean it.
I
Occasionally wipe the outside of the appliance with a damp cloth.
Regularly wash and dry the drip tray and its grid.
I
Do not use alcohol-based or abrasive cleaning products or solvents.
I
Regularly clean the grid through which the hot water passes with a damp
sponge.
I
Important: Never use soap or other cleaning agents as it will impact the
taste of your beverages.
14:59 Page 12