Sauder 422194 Instrucciones De Manejo página 9

Step 4
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the LEFT END (B) until the shoulders of the SCREWS rest
on the surfaces of the END.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDING (K) onto the LEFT END (B). Line
å
up the grooves in the MOLDINGS over the heads of the
SCREWS in the END .
NOTE: The MOLDING should be even on both edges of
å
the ENDS
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
www.sauder.com/services
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
B
422194
32S
K
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 9