Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
colder
5W30
Viscosity Chart
NOTE: Although multi-viscosity oils (5W30, 10W30
etc.) improve starting in cold weather, these multi-
viscosity oils will result in increased oil consumption
o
when used above 32
F. Check your snow thrower's
engine oil level more frequently to avoid possible
engine damage from running low on oil.
Refer to the viscosity chart for proper selection of
engine oil.
Checking Oil Level
•
Before operating the snow thrower, check the oil
level.
•
With engine on level ground, the oil must be to
FULL mark on dipstick.
•
Stop engine and wait several minutes before
checking oil level. Remove oil fill cap and
dipstick.
•
Wipe dipstick clean, insert it into oil fill hole and
tighten securely.
•
Remove dipstick and check. If oil is not up to the
FULL mark on dipstick, add oil.
Changing Oil
Change engine oil after first two hours of operation
and every 25 hours thereafter.
In order to change the oil, you will have to first drain
the spent engine oil from the engine and then refill
with fresh oil.
o
32
F
warmer
SAE30
•
Drain oil while engine is warm. Remove oil drain
cap located at bottom of the recoil starter of the
engine. Catch oil in a suitable container.
•
When engine is drained of all oil, replace drain
plug securely.
•
Remove the dipstick from the oil fill. For location
of the oil fill, see Figure 18. Pour fresh oil slowly
through the plug. Replace dipstick.
•
Check and make sure that the level of oil is up to
the FULL mark on the dipstick.
WARNING:
nearby areas may exceed 150
Avoid these areas.
Spark Plug
•
Clean area around the spark plug base.
•
Remove and inspect the spark plug.
•
Replace the spark plug if electrodes are pitted,
burned, or the porcelain is cracked. See Figure 21.
•
Clean the spark plug and reset the gap to 0.030"
at least once a season or every 50 hours of
operation. See Figure 21.
•
Spark plug replacement is recommended at the
start of each season. Refer to engine parts list
for correct spark plug type.
NOTE: Do not sandblast spark plug. Spark plug
should be cleaned by scraping or wire brushing and
washing with a commercial solvent.
Electrodes
.030"
Gap
19
Temperature of muffler and
o
F(65
Porcelain
Figure 21
o
C).
Publicidad
Tabla de contenido
