Rear Connections - Numark CD MIX 2 Manual De Inicio Rápido Del Usuario

1. Make sure all items listed on the front of this guide
are included in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE
USING THE PRODUCT.
3. Study this setup diagram.
4. Place CDMIX2 station in an appropriate position for
operation.
5. Make sure all devices are turned off and all faders
and gain knobs are set to "zero"
6. Connect all stereo input sources as indicated in the
diagram.
7. Connect the stereo outputs to power amplifier(s),
tape decks, and/or other audio sources.
8. Plug all devices into power.
1. Channel Inputs: Unbalanced RCA jacks for
connecting external sources. The Phono/Line input is
selected using the toggle switch on the front panel.
Turntables, HiFi VCRs, cassette and reel-to-reel tape
decks, DAT machines, CD players, laser discs, tuners,
even synthesizers or other mixing consoles can be
connected using these jacks. NOTE: Plug mono audio
sources into both left and right inputs using a "Y"
cable connector.
2. GND: This screw connector should be used to connect
any turntables or other devices that need to be
grounded.
CDMIX2 QUICK SETUP
9.
10.
11.
More information about this product may be found at

REAR CONNECTIONS

3. Line/Phono Input Switch: Use this to allow either
line level or phono level equipment to be plugged into
your channel inputs. When Phono input is selected,
your signal is fed directly to the high-quality RIAA
phono pre-amplifiers. Use this position only for
turntables. Line level sources will overload the
sensitive phono pre-amps and will sound very bad, so
always be sure to toggle the line/phono switch over to
line before connection of line sources.
4. Line Input: Plug in a line level device such as a tape
deck or additional CD player here.
5. Master Output (RCA): This output is for connecting
an external monitoring device such as a PA system,
2
Switch everything on in the following order:
• audio input sources (i.e. turntables or CD
players)
• CDMIX2
• last, any amplifiers or output devices
When turning off, always reverse this operation by,
• turning off amplifiers
• CDMIX2
• last, any input devices
Go to http://www.numark.com for product
registration.
http://www.numark.com