Safety Codes And Standards; Electric Safety - Gaggenau VL 200 120 Instrucciones De Instalación

9 IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
9
WARNING
Risk of tipping over!
The appliance is very narrow and can
tip over easily. Do not place
appliance upright on the floor. Place
the appliance flat on the floor.

Safety Codes and Standards

This appliance complies with the latest
version of one or more of the following
standards:
UL 507 - Electric Fans
▯
CAN/CSA C22.2 No. 113 - Fans and
▯
Ventilators
It is the responsibility of the installer to
determine if additional requirements and/
or standards apply to specific
installations.

Electric Safety

9
WARNING
GROUNDING INSTRUCTIONS!
This appliance must be grounded. In
the event of an electrical short
circuit, grounding reduces the risk of
electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
cord having a grounding wire with a
grounding plug. The plug must be
plugged into an outlet that is
properly installed and grounded.
6
9
WARNING
Improper grounding can result in a
risk of electric shock. Consult a
qualified electrician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded. Do not use an extension
cord. If the power supply cord is too
short, have a qualified electrician
install an outlet near the appliance.
9
WARNING
Before you plug in an electrical cord
or turn on power supply, make sure
all controls are in the OFF position.
For appliances equipped with a cord and
plug, do not cut or remove the ground
prong. It must be plugged into a matching
grounding type receptacle to avoid
electrical shock. If there is any doubt as
to whether the wall receptacle is properly
grounded, the customer should have it
checked by a qualified electrician.
If required by the National Electrical
Code (or Canadian Electrical Code), this
appliance must be installed on a separate
branch circuit.
9
WARNING
To reduce the risk of fire or electric
shock, do not use this fan with any
solid-state speed control device.