Ebode IR Link Pro Flush Guia Del Usuario página 4

This kit contains two 3IREDB Triple Blinking Emitters for control of 6 devices, and a 1IRQC Quick
Connect cable for direct control of popular Audio/Video Receivers (e.g. Yamaha, Onkyo,
Denon, Marantz, NAD, Harman Kardon, Pioneer, Sony etc). The IR Link Pro Flush Kit runs on a
12VDC mains adapter (included) and is expandable with extra IR Link Receivers in different
rooms.
The IR Link Pro Flush Kit is a mains powered InfraRed Extender System that allows full remote
control operation of audio/video components (such as your Blu-ray player, A/V Receiver, DVR,
Satellite Box, Cable Tuner, etc.) which are located behind closed cabinet doors, in other rooms,
or other concealed and/or out-of-sight locations.
An InfraRed Extender in general consists of an IR (InfraRed) capture device, the IR Receiver, a
distribution circuit/connecting block, the IR Hub, and finally the IR LED output, the IR Emitter,
which flashes the IR signal to the A/V component.
3. Kit content
The IR Link Pro Flush Kit is a pre-packaged InfraRed Remote Control Extender System. It includes
an IRLPRO Flush Mount IR Receiver with 4 interchangeable, coloured top covers (black, white,
brushed chrome and brass), an IRHUB4 Connecting Hub with 4 Emitter outputs + Status input
Jumper Cable, two 3IREDB Triple Blinking Emitters, a 1IRQC Quick Connect cable and a 12VDC
Power Supply. These parts are all that are necessary to control up to 7 components.
4. How does the ebode IR Link Pro Flush work?
The ebode IR Link Pro Flush is intended for use in IR control systems where the IRHUB4 Connecting
Hub is within reach of the 2-meter cable of the IRLPRO IR Receiver, e.g. when installing the IR Link
Pro Flush Kit in a cabinet where the controlled components are behind closed doors, and the
IRLPRO Flush Receiver can i.e. be mounted into the cabinet (see step 3 in chapter 5), but always
within line of sight of your hand held remotes.
5. Installing the ebode IR Link Pro Flush
The IRHUB4 sockets are colour coded for easy plug & play installation of the IR Receiver and IRED
Emitters, which have coloured jacks.
A typical system is shown in Fig. 1 below. Refer to this diagram and the procedure that follows
when making connections:
Fig 1
31-12-2010 4 IR Link Pro Flush