Testing For Continuity - Surtek 111005 Manual De Usuario

D.

Testing for Continuity

(Figure 6)
To avoid damages to the Meter or to the
devices under test, disconnect circuit power and
discharge all the high-voltage capacitors before
To test for continuity, connect the Meter as below:
1. Insert the red test lead into the
and the black test lead into the COM terminal.
2. Set the rotary switch to
select measurement mode.
3. The buzzer sounds if the resistance of a circuit under
test is less than around 70Ω.
Note:
• The LCD displays OL indicating the circuit being tested
is open.
• When continuity testing has been completed,
disconnect the connection between the testing leads
and the circuit under test, and remove the testing leads
away from the input terminals of the Meter.
Warning
testing for continuity.
E N G L I S H
Hz Ω terminal
and press BLUE button to
Figure 6
35