Operation Of Hold Mode; The Use Of Relative Value Mode; The Blue Button - Surtek 111005 Manual De Usuario

Multímetro digital profesional con gancho
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION OF HOLD MODE

To avoid possibility of electric shock, do not
use Hold mode to determine if circuits are
without power. The Hold mode will not
capture unstable or noisy readings.
The Hold mode is applicable to all measurement
functions.
• Press HOLD to enter Hold mode; the Meter beeps.
• Press HOLD again or turn the rotary switch to exit
Hold mode; the Meter beeps.
• In HOLD mode,

THE USE OF RELATIVE VALUE MODE

The, REL mode applies to all measurement functions
except frequency/duty cycle, diode and continuity
measurement. It subtracts a stored value from the
present measurement value and displays the result.
For instance, if the stored value is 20 V and the present,
measurement value is 22 V, the reading would be 2 V. If
a new measurement value is equal to the stored value
then display 0 V.
To enter or exit REL mode:
• Use rotary switch to select the measurement function
before selecting
changes manually, after
exits the REL mode.
• Press
off except under capacitance testing mode, and the
present measurement range is locked and display 'O'
as the stored value.
• Press
the stored value and exit REL mode.
• Pressing HOLD in REL mode makes the Meter stop
updating.
• Pressing HOLD again to resume updating.

THE BLUE BUTTON

It uses for selecting the required measurement function
when there is more than one function at one position of
the rotary switch.
Warning
is displayed.
. If measurement function
to enter REL mode, auto ranging turns
again or turn the rotary switch to reset
E N G L I S H
is selected, the Meter
41

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido