Panasonic AW-PH400 Manual De Operación página 30

Pan/Tilt Head Controller AW-RP400
Menu settings
MONITOR SELECT setting
This menu item is used to select the controller used to switch the images of the AW-RC400's MONITOR2 output when the
AW-CB400 remote operation panel and a second AW-RP400 have been connected to this AW-RP400 controller and the
AW-RC400 cable compensator is used.
By setting the master AW-RP400 and slave AW-RP400, the camera images which have been selected by the controller given
in the table below are output as the AW-RC400's monitor output.
Master unit
MON2 = CB400
MON2 = SLAVE
When the cable compensator has been connected to the slave AW-RP400, the images selected by the slave
AW-RP400 are output to MONITOR1 on the AW-RP400 and the images selected by the slave AW-CB400 are output
to MONITOR2 regardless of this setting.
BUZZER setting (OFF/ON)
This menu item is used to select ON or OFF for the buzzer inside the controller. The buzzer does not sound at the OFF
setting.
The buzzer sounds when the CALL button has been pressed or when a tracing memory operation (record, play or change) is
started, suspended or ended.
AUTO RUN setting (START No., END No., INTERVAL)
This menu item enables the presets of the pan/tilt head to be repeated automatically.
START No. (1 to 50):
END No. (1 to 50):
INTERVAL (1s to 30s):
OPERATE (STOP/RUN): When RUN is selected, the presets from the START No. to STOP No. are played repeatedly;
SD CARD setting
The menu setting data of this controller, the preset memory data of the pan/tilt heads and the setting data of the cameras can
be stored on SD memory cards.
If the MENU button is pressed while STORE is displayed, the setting data is stored on the SD memory card.
If the MENU button is pressed while LOAD is displayed, the data stored on the SD memory card is called, and the settings
are loaded into the controller, pan/tilt heads and cameras.
≥ The tracing memory data is not stored.
AW-RP400 menu setting
Slave unit
MONITOR2 = setting disabled
MONITOR2 = RP400
MONITOR2 = CB400
This sets the first number of the preset to be repeated.
This sets the last number of the preset to be repeated.
This sets the stop time at the preset position.
Up to 30 seconds can be set in 1-second increments for the stop time.
when STOP is selected, operation stops.
When the PAN/TILT lever is operated, STOP is selected automatically, and operation stops.
MONITOR1
Master RP400
Master RP400
Master RP400
29 (E)
AW-RC400
MONITOR2
Master CB400
Slave RP400
Slave CB400