Installation Instructions
Please Read Before Installing
HWI-KP5-DN Keypad
Indicator
LEDs
HWI-KP5-DW Keypad
Indicator
LEDs
HWI-LB5-DC1 Keypad
Button 1
Button 2
Indicator
Button 3
LEDs
Button 4
Button 5
Button 24
Button 23
2
Button 1
Button 2
Button 3
Button 4
Button 5
Button 24
Button 23
Button 1
Button 2
Button 3
Button 4
Button 5
Button 24
Button 23
HWI-KP5-DN
HWI-KP5-DW
HWI-LB5-DC1
Description
The HWI-KP5-DN, HWI-KP5-DW, and HWI-LB5-DC1
are for use with HomeWorks
The keypad buttons are programmed with a personal
computer through your HomeWorks
processor using the HomeWorks
Up to 32 keypads, each with a unique address, can
be connected to each keypad link on the
HomeWorks
Interactive
®
300 keypad LEDs can be connected per processor. To
increase the number of LEDs, see the HomeWorks
Interactive
Technical Reference Guide.
TM
Installation
1.
Disconnect power to the keypads by turning off
all circuit breakers connected to the
HomeWorks
Interactive
®
link auxiliary power supply. Wiring with power
ON may result in personal injury.
2.
Address keypads. Assign a unique address to
each keypad using the DIP switch on the back of
the keypad. See Figure 2 (page 3) for DIP switch
locations. See Figure 3 (page 4) for DIP switch
settings. Be sure to record the address for future
programming purposes.
3.
Strip insulation or trim wires to 3/8" (10mm). Each
terminal will accept one or two 18-gauge
(1.0mm
2
) wires.
4.
Unplug terminal block from the keypad circuit
board.
5.
Connect wiring to terminal block as shown in
Figures 1 and 2 (page 3).
6.
Plug the keypad terminal block back onto the
circuit board. Be sure to orient the terminal block
correctly.
7.
Mount keypad according to the appropriate
Mounting Diagram in Figure 4 (page 4). Do not
over-tighten mounting screws.
8.
Restore power to the HomeWorks
Panel.
5-Button Keypad
5-Button Keypad
5-Button Keypad
Interactive
systems.
®
TM
Interactive
®
TM
Interactive
Utility.
®
TM
processor. A maximum of
TM
Processor or keypad
TM
Interactive
®
®
TM