Sauder Queen Platform Bed 414866 Instrucciones De Manejo página 12

Step 8
Fasten the LONG ENDS (E and F) to
å
the DRAWERS UPRIGHTS (J). Tighten two
HIDDEN CAMS.
Fasten the LONG ENDS (E and F) to the
å
UPRIGHTS (H and I). Use four BLACK 1-7/8"
FLAT HEAD SCREWS (2S).
NOTE: These ENDS attach to the UPRIGHTS
å
with the DRAWERS
NOTE: END (E) will hang over
å
the UPRIGHTS (H, I, and J).
DRAWERS on the left
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Page 12
Hole is closer to
the bottom edge.
Hole is closer to the
top FINISHED edge.
J
H
Hole is closer to the
2S
top FINISHED edge.
Start
Arrow
E
J
F
H
I
Hole is closer to
the bottom edge.
E
F
Tighten
Maximum
210 degrees
Minimum
190 degrees
414866
Unfi nished surface
I
DRAWERS on the right
2S
BLACK 1-7/8" FLAT HEAD SCREW
(4 used in this step)
Finished surface
Arrow
www.sauder.com/services