Extension Rail; Gold 5/16" Flat Head Screw - Sauder Queen Platform Bed 414866 Instrucciones De Manejo

Step 4
Separate the EXTENSION SLIDES (V) from the
å
EXTENSION RAILS (U) as shown in the lower diagram. Be
prepared, the parts are greasy.
Fasten two EXTENSION RAILS (U) to a DRAWER
å
UPRIGHT (J) as shown in the upper diagram. Use four
GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: One UPRIGHT (J) will not have EXTENSION RAILS
å
fastened to it.
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
inner cartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the UPRIGHTS. Turn a
SCREW into this hole.
Open end
Page 8
V
Push the black lever in and pull the SLIDE from the RAIL.
414866
U
J
U

GOLD 5/16" FLAT HEAD SCREW

(4 used in this step)
3S
U
www.sauder.com/services