Pull; Black 1-9/16" Flat Head Screw - Sauder Queen Platform Bed 414866 Instrucciones De Manejo

Step 14
1
Q
D50
Pull the DRAWER FRONT BRACKETS (9G) apart
å
and slide them into the grooves in the DRAWER
SIDES (D50 and D51). You may need to gently tap them in
with a hammer.
NOTE: The DRAWER FRONT BRACKETS are marked "RH"
å
and "LH" for easy identifi cation.
Fasten the DRAWER FRONT (Q) to the DRAWER FRONT
å
BRACKETS (9G). Use four BLACK 9/16" LARGE
HEAD SCREWS (1S).
1
2
Fasten the DRAWER BRACE (T) to the DRAWER
å
FRONT (Q). Tighten one HIDDEN CAM.
Fasten the DRAWER BACK (D80) to the DRAWER
å
SIDES (D50 and D51) and DRAWER BRACE (T). Use fi ve
BLACK 1-9/16" FLAT HEAD SCREWS.
Repeat this step for the other drawer.
å
Page 18
Push down
D51
BLACK 9/16" LARGE HEAD SCREW
(8 used for the BRACKETS)
Start each screw a few turns before
3
completely tightening any of them.
2
1S
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D986) into the grooves in
å
the DRAWER SIDES (D50 and D51) and
DRAWER FRONT (Q).
D50
T
Q
414866
With the palm of your hand, tap the DRAWER
BOTTOM down into the groove.
U N
F I N
I S H
E D
D50
D986
Q

BLACK 1-9/16" FLAT HEAD SCREW

(10 used in this step)
D80
D51
www.sauder.com/services
D51
30S