Step 9
NOTE: The rest of the diagrams will be shown with the
å
DRAWERS on the left.
Fasten the REAR LONG ENDS (C and D) to the
å
UPRIGHTS (J). Tighten two HIDDEN CAMS.
Fasten the REAR LONG ENDS (C and D) to the
å
UPRIGHTS (H and I). Use four BLACK 1-7/8" FLAT
HEAD SCREWS (2S).
NOTE: END (C) will hang over the UPRIGHTS (H, I, and J).
å
BLACK 1-7/8" FLAT HEAD SCREW
Hole is closer to
the bottom edge.
Hole is closer to
the top edge.
www.sauder.com/services
2S
(4 used in this step)
C
D
H
Maximum
210 degrees
Minimum
190 degrees
I
J
414866
Arrow
Page 13