HoMedics enviraScape MARIPOSA WFL-MARI Manual De Instrucciones E Información De Garantía página 3

CAUTION CONTINUED
• The electrical cord of this product cannot be replaced. If it sustains
damage, you must stop using this product immediately and return it to
the HoMedics Service Center for repair. (See the warranty section for
HoMedics address.)
• Disconnect the appliance from outlet before putting hands into water.
Assembly and Instructions for Use
1. Place the Base on a flat surface. (Fig 1)
2. Attach the Holder to the slots located at the underside of Leaf 3. Align
the mark "ARROW" at the underside of Leaf 3 with the mark "ARROW"
on the tray of the Holder.
3. Slide the Small Bulb attached to the Pump into the plastic plug of the
light tube at the underside of Leaf 3. Connect the Water Supply Tube
over the inlet at the underside of Leaf 3, then insert the small end of the
Water Supply Tube into the pump outlet.
4. Place the Holder with Leaf 3 attached, onto the Base. Align the Holder
Notch with the Tab at the edge of the Base.
Figure 1
Leaf 1
Leaf 2
Water
Leaf 3
Supply Tube
Transformer
Holder
Small Bulb
Pump
Base
Hoja 1
4
Hoja 2
5. Place Leaf 2 on the pillar of Leaf 3, then place Leaf 1 on top. (Fig 2)
6. Add appropriate clean water into the Base and the water level should be
even with the watermark. Place stones on Leaves 1, 2, 3 and the Base
for decoration. (Fig 3)
7. To achieve the best water movement, adjust Leaf 1 and Leaf 2 by
rotating slightly.
Switch
Figure 2
Leaf 1
Leaf 2
Leaf 3
Figure 3
Stones
Water
Watermark
5