Overhead Rigging - Briteq COB SLIM 100-RGB Manual De Instrucciones

ENGLISH
IR-REMOTE
Note: Make sure that the IR-remote option in the setup menu is switched ON before you start using the
remote control.
1. BLACKOUT-button: used to switch the output ON/OFF
2. COLOR-button: used to select one of the pre-programmed static colors of the projector. First press the
COLOR-button, followed by one of the 10 number buttons to select the desired color.
3. COLOR (NUMBER) buttons: each buttons represents a color.
 1-button: warm white
 2-button: cold white
 3-button: red
 4-button: orange
 5-button: yellow
 6-button: green
 7-button: cyan
 8-button: blue
 9-button: purple
 0-button: custom color (previously saved in memory)
4. PROG-button: used to select one of the effect programs.
With each press you go to the next effect:
 Press 1x: Color change 7colors selected
 Press 2x: Color change 3colors selected
 Press 3x: Color fade effect selected
5. STROB-button: used to switch the strobe function
ON/OFF. First press the STROB-button, followed by the
±buttons (7) to adjust the strobe speed.
Remark: works on the effect programs.
6. SPEED-button: used to adjust the speed of the effect programs. First press the SPEED-button, followed
by the ±buttons (7) to adjust the program speed.
7. ±-Buttons: used to increase / decrease the value of the selected function.
8. CUSTOM COLOR ADJUST-buttons: press one of these buttons to select the static custom color and
adjust one of its color components:
 Press the R-button: followed by the ±buttons (7) to adjust the red component in the custom color.
 Press the G-button: followed by the ±buttons (7) to adjust the green component in the custom color.
 Press the B-button: followed by the ±buttons (7) to adjust the blue component in the custom color.
9. DIM-button: followed by the ±buttons (7) to adjust the GENERAL DIMMER.
10. F2-button: not used for this projector
11. SOUND-button: used to start the sound activated programs
12. F1-button: not used for this projector
13. Battery compartment: receives a CR2025 3V-battery (supplied).

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device
when installing the unit. This secondary safety attachment should be installed in a way
that no part of the installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not
be considered!
 Don't cover any ventilation openings as this may result in overheating.
BRITEQ
®
4/67
OPERATION MANUAL
COB SLIM100-RGB