Overhead Rigging - Briteq POWERPIXEL4-RGB Manual De Instrucciones

ENGLISH
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
Note: POWERPIXEL4-RGB shown, POWERPIXEL8-RGB has identical controls & connections.
1. MAINS INPUT: equipped with original Neutrik PowerCON
®
PowerCon extension cable here.
2. MAINS OUTPUT: used to daisy chain the power to several other projectors. Always pay attention to the
maximum load while adding projectors! Special Multi cables (PowerCON
optionally available: see our website!)
3. MAINS FUSE: protects the unit in case of electrical problems, always use the prescribed fuse!
4. DMX IN/OUT: both 3pin and 5pin in/outputs are available to daisy chain the projector with other units that
will be controlled by a DMX-controller.
5. MODE Button: used to browse the different options of the setup menu.
6. ENTER Button: used to jump between different parameters of the selected option. Also confirms the
selected values of the parameters.
7. UP/DOWN Buttons: used to increase/decrease the value of the selected parameter.
8. LCD DISPLAY: backlit 2x 16character LCD-display for easy navigation. The backlight lights up as soon
as one of the buttons is pressed. Shows the model + software version at startup.
9. MIC: used to trigger the programs in music mode.
10. BRACKET: multifunctional and very stable design for both floor and truss mounting. The projector can be
directed in any direction.
11. SAFETY EYEBOLT: used to attach a safety cable when the unit is rigged (see paragraph "overhead
rigging"

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
BRITEQ
®
®
. Connect the supplied mains cable or any
3/64
OPERATION MANUAL
®
+ DMX XLR-cables are
POWERPIXEL4+8-RGB