Hoses; Diffuser Cap Assembly - RIDGID WD55000 El Manual Del Propietario

Ocultar thumbs Ver también para WD55000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SP6625 5 gallon RIDGID

Hoses

(14 Foot Tug-A-Long & 7 Foot
Super Flex)
The 14 Foot Tug-A-Long Hose and the
7 Foot Super Flex Hose have an adaptor
that can be used to connect the hose to
the vacuum port on the vac or to the male
end of another hose. Both 7 foot and 14
foot hoses can be used connected togeth-
er or independently from one another.
Both the 7 foot and 14 foot hoses have a
locking adaptor at one end that will
connect to the vac, and a friction fit
at the other end, which will connect to all
the 1-7/8 inch accessories or a second
hose.
To connect these two hoses together, first
connect the 14 foot hose to the wet/dry
vac. Next connect the 7 foot hose to the
14 foot hose by inserting the friction end of
the longer hose into the larger locking end
of the shorter hose. This will create a
friction connection.
Vacuum Inlet Port
Friction
End
Vacuum Inlet
Port
9/16/05
2:25 PM
Male End
of Hose
Tug-A-Long
Hose
Page 13

Diffuser Cap Assembly

Connect the lanyard to the attachment tab
on the vac motor assembly to keep the
diffuser attached to vac when using the
blower port. The diffuser cap can be used
in the exhaust port of the Wet/Dry Vac.
Installing the diffuser cap will allow you to
diffuse the exhaust air in any direction and
reduce the intensity of the exhaust force.
Attachment Tab
Lanyard
Diffuser
13

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido