Measuring Distances - Flex ADM1 Instrucciones De Funcionamiento

Operating instructions
– Displayed unit of measurement = metres
(m)
Switch off the machine:
n Hold down On/Off button (9) for approx.
2 seconds. The display goes out.
2SXIW
r 8LI HIZMGI W[MXGLIW SJJ EYXSQEXMGEPP]
EJXIV  QMRYXIW
r ;LIR XLI HIZMGI W[MXGLIW SJJ EPP WEZIH
VIEHMRKW EVI HIPIXIH
Switching over reference point
The reference point is the starting point when
measuring distances. The following reference
points can be selected:
– Lower side of device
– Upper side of device
To switch over the reference point:
n Switch on the device.
n Press Switchover button for reference
point (8).
The symbol for the reference point is
indicated on the front of the display (2).
Switching over displayed unit
of measurement
When the measurement has been taken,
the unit of measurement of the displayed
reading can be indicated in the following
sequence by repeatedly pressing the
Switchover button (10) (example:
distance = 1.000 m):
Distance
1. 1.000 m
2. 1000 mm
3. 7
3' 3 "
/
16
4. 3.281 ft
The next measurement is then taken with the
last selected unit of measurement.

Measuring distances

'EYXMSR
(S RSX TSMRX E PEWIV FIEQ EX TIVWSRW SV
ERMQEPW (S RSX PSSO MRXS XLI PEWIV FIEQ
2IZIV PSSO MRXS XLI PEWIV FIEQ IMXLIV HMVIGXP]
SV [MXL STXMGEP MRWXVYQIRXW
n Switch on the device.
n Press Measurement button (6) once.
n Aim laser dot at the required target.
If required, use the spirit level (1) to aim
the device.
n Press Measurement button again (6)
to take the measurement.
Area Volume
m² m³
m² m³
ft² ft³
ft² ft³
The laser beam
symbol is indicated
on the display (2)
above the reference
symbol.
The measured
distance is indicated
on the lower line of
the display (2).
17