Maintenance And Care; Disposal Information - Flex ADM1 Instrucciones De Funcionamiento

Operating instructions
Remedial action:
Object must be within the measurement
range (0.3–45 m/1–150 ft.). If possible,
measure distance in sections and add.
Remedial action:
Change object or attach suitable target area
(1 sheet of white paper) to object.
Remedial action:
Reduce/switch off ambient lighting.
Remedial action:
When taking a measurement, always hold
the device still and vibration-free.
Remedial action:
Always measure the cathetus first (shorter of
the two measured distances), then measure
the hypotenuse.
Error message:
The object aimed at
is outside the range
of the device.
Error message:
The object aimed at
is too reflective or is
too dark.
Error message:
Ambient light is
too bright.
Error message:
The device was not
held still during the
measurement.
Error message:
Incorrect input for
indirect measure-
ment of a distance.

Maintenance and care

Cleaning
If the power tool is damp after use, wipe the
power tool and accessories with a dry, soft
cloth.
Do not use solvents or abrasive cleaning
agents to remove dirt. Use a clean cloth
moistened with water and a mild detergent.
Remove dust, etc. from the discharge
windows for the laser beams (5) with
a soft cloth.
Repairs
Repairs may be carried out by an authorised
customer service centre only.

Disposal information

EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2002/96/EG on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
2SXI
4PIEWI EWO ]SYV HIEPIV EFSYX HMWTSWEP
STXMSRW
(MWTSWI SJ FEXXIVMIW EGGSVHMRK XS XLI
GYVVIRXP] ZEPMH GSYRXV]WTIGMJMG KYMHIPMRIW
21