Beninca KT3 Libro De Instrucciones página 7

Off= Forewarning flashing disabled
On= Forewarning flashing enabled
Trimmer functions
The trimmers adjust the triggering threshold of the current sensor. A different threshold can be selected
in the Opening and Closing phases.
N.B.: On opening, if the threshold of intervention of the current sensor is exceeded, the motor stops. On
closing, if the threshold of intervention of the current sensor is exceeded, if the motor is decelerating it stops,
whereas if it is at the maximum set speed it inverts its direction of movement for 2 sec. and then stops.
Programming of the control unit
To erase the remote control codes from memory
To erase the remote control unit codes from memory power the control unit keeping the programming key
PGM pressed. The flashing light and the courtesy light will switch on simultaneously for about 5 seconds.
When they switch off the memory is erased.
To store a new remote control code in memory
Press the programming key PGM, the courtesy light will start flashing until the new code is received and
stored. If, after pressing the key, the courtesy light does not flash, but the flashing light switches on for
5S, this means that memory is full and no other codes can be stored in memory.
To facilitate calibration of the limit switches the motor movement can be directly controlled by pressing the
key on the board: the motor causes the movement for as long as the key is kept pressed.
The operating time of the control unit is 45 seconds.
The dwell time for the automatic closure is 15 seconds.
The time for the courtesy light is 80 seconds.
7