Publicidad
Idiomas disponibles
Idiomas disponibles
Contents
Ref. Description
1
GB
2
3
4
1.
Before
2.
installation
3.
4.
Read this instruction manual carefully. "Special" information is described with the following
Important
symbols/words. Take care of these points.
IMPORTANT
It is necessary to disconnect the negative pole of the battery before connecting wires.
The system is planned for motorbikes having 12V battery.
Installation and connections should be done by high professional qualified personnel only. If you do not feel technical
qualified to install this product on your own, please consult with your nearest SUZUKI dealer.
INSTALLATION
1.
Technical features
Supply voltage
Absorbed current
Operating temperature
2.
Preliminary operations
Dismount the shield (picture 2) in accordance to the owners manual (page 6/29).
3.
Connections
(see picture 1)
1)
Fit the alarm system by using the hexagonal-head screw on the bike (picture 4).
2)
Disconnect the two wires from the horn and connect the orange/black wire to the blue wire of the alarm system.
Then connect the black/green wire to the green wire of the alarm system.
3)
Connect the blue/black and green/black wires of the alarm system to the horn.
4)
Identify the 4-pin connector (picture 5-A) of the alarm system prearrangement and insert the alarm harness
counterpart.
5)
+ 12V: identify the 1-pin connector (picture 5-B) and insert alarm the harness counterpart.
6)
Place the led as shown in picture 3.
7)
Secure all cables by using the provided cable ties to prevent damages.
8)
Replace all parts you removed earlier from the motorcycle.
4.
System test
1)
Put ignition key in ON position for few seconds, and then in OFF position.
2)
30 seconds from the engine cut off, the system is automatically arming: LED is blinking.
3)
Simulate a theft attempt: remove the motorcycle from its stand and move it for few meters. The system detects the
movement and the horn sounds for 30 sec. (it is possible to deactivate the system before 30 sec. giving 3 consecutive key
turns ON-OFF).
4)
End of testing.
2
Main unit
Wired led
Installer – User instructions
Cable tie
Park the motorbike steady in a safe place.
Keep the ignition key removed.
Be sure not to damage any vehicle part.
Check that all the parts are contained in the kit as shown in "Contents" section.
Shows risk for your life and health.
WARNING
IMPORTANT
Show risks which can damage your bike.
REMARK
Contain special information to fit/maintain parts easily.
12 V dc
0,2 mA
-40°C / +85°C
SUZUKI GENUINE ACCESSORIES
Tools
Q.ty
1
1
1
PH2
3
10
Publicidad
