Residual Risks; Vibration; Labels On Tool; Maintenance - SKF LINCOLN PowerLuber A Serie Guía De Instalación Y Mantenimiento

Warning

Do not use any hose not approved by
Lincoln. Extreme pressure may cause
nozzle extension or whip hose to burst.
Replace hose at first sign of wear,
kinks, or damage to outside jacket.
Follow whip hose instructions and
warnings. Failure to comply may result
in serious injury or death.
Warning

Grease gun can develop high pressure
up to 10,000 psi (689 bar). Use safety
glasses and gloves for protection during
operation. Keep hands clear of exposed
rubber portion of hose.

Residual risks

Additional residual risks may arise when
using the tool which may not be included in
the enclosed safety warnings. These risks
can arise from misuse, prolonged use, etc.
Even with the application of the relevant
safety regulations and the implementation
of safety devices, certain residual risks can
not be avoided. These include:
• Injuries caused by touching any rotating/
moving parts.
• Injuries caused when changing any parts,
blades or accessories.
• Injuries caused by prolonged use of a tool.
When using any tool for prolonged peri-
ods ensure you take regular breaks.
• Impairment of hearing.
• Health hazards caused by breathing dust
developed when using your tool (exam-
ple: working with wood, especially oak,
beech and MDF.)
Warning

Vibration emission value during actual
use of power tool can differ from
declared value depending on ways in
which the tool is used. Vibration level
may increase above level stated.

Vibration

The declared vibration emission values
stated in the technical data and the declara-
tion of conformity have been measured in
accordance with a standard test method
provided by EN 60745 and may be used for
comparing one tool with another.
The declared vibration emission value may
also be used in a preliminary assessment of
exposure.
When assessing vibration exposure to
determine safety measures required by
2002/44/EC to protect persons regularly
using power tools in employment, an
estimation of vibration exposure should
consider the actual conditions of use and the
way the tool is used, including taking
ac- count of all parts of the operating cycle
such as the times when the tool is switched
off and when it is running idle in addition to
the trigger time.

Labels on tool

The following symbols are shown on the
tool.
Warning

Do not use tool before reading
instruction manual to reduce
risk of injury.
5

Maintenance

The PowerLuber has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous satis-
factory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any main-
tenance apart from regular cleaning.
Warning

Do not perform maintenance on tool
with battery installed.
Do not clean charger with it plugged
in.
note
Regularly clean ventilation slots in tool
and charger using a soft brush or dry
cloth.
Regularly clean motor housing using
a damp cloth. Do not use any abrasive
or solvent-based cleaner.
Regularly open chuck and tap it to
remove any dust.