Troubleshooting - SKF LINCOLN PowerLuber A Serie Guía De Instalación Y Mantenimiento

Troubleshooting

Condition
PowerLuber fails to dispense grease.
PowerLuber continues to lose prime.
Battery fails to take a charge.
Motor fails to run.
Parts list
No. Part no. Description
1 280213 Hardware kit (1260)
2 280208 Pump assembly kit (1260)
3 1230 Hose, .125 in. (3,1 mm) ID x 30 in. (762 mm)
4 280235 Trigger, switch kit
5 280211 Decal kit
6 280210 Handle with screws kit
7 1261 Battery
8 5852 Coupler, midget hydraulic
9 280209 Electrical components kit
10 271882 Grease tube kit
11 280233 Seal kit (1260)
12 280212 Housing with bearing kit
13 271893 Motor with plate kit
14 280214 Gear set kit (1260)
15 280215 Piston, yoke kit
16 280232 Driver assembly kit
17 280231 Check valve kit
18 286315 Vent valve kit
Possible cause
Grease tube assembly is out of grease.
Loss of prime.
Ball check is not functioning.
Clogged whip hose.
Air may be trapped in several locations in container
after bulk filling.
Follower may be binding in grease tube assembly.
Check ball seat and check ball dirty.
Charger may not have power.
Battery may be bad.
Battery needs charging.
Faulty wiring to motor.
Table 8
15
Corrective action
Check that grease tube assembly has grease.
Repeat priming operation.
Remove ball check clean and inspect ball seat area.
Clean or replace whip hose.
Empty grease tube assembly, refill and repeat
priming instructions.
Disassemble grease tube assembly and clean.
Be sure that follower has properly entered the grease
cartridge.
Verify that the follower is not caught on the rim of the
grease cartridge.
Replace grease tube assembly (5) if damaged.
Clean check ball and check ball seat.
Check that receptacle has power.
Replace battery.
Recharge battery.
Remove battery, disassemble handle and check wir-
ing connections on terminal, trigger switch and
motor.
Table 7