How To Set The Time And Date - Seiko 8R48 Instrucciones

* There is no need to turn the crown further when the mainspring is fully wound. But
the crown can be turned without damaging the watch mechanism.
* Once the watch is wound up fully, it operates for about 45 hours. However, when
the stopwatch is used continuously for a certain period, the watch may not operate
for as long as 45 hours.
* If the watch is used without being wound up fully, gain or loss of the watch may
result. To avoid this, wear the watch for more than 10 hours a day. If the watch
is used without being worn on the wrist (if it is used on the desk like a clock, for
example), make sure to wind it up fully every day at a fixed time.
* If the watch has stopped with the mainspring unwound, winding the mainspring
with the crown will not start the watch immediately. This is because the mainspring
torque (force) is low at the beginning of its winding due to the characteristics of
mechanical watches. The small second hand starts to move when a certain degree
of strong torque is reached after the mainspring has been wound up. However,
swinging the watch from side to side to forcibly turn the balance can start the watch
sooner.
8

HOW TO SET THE TIME AND DATE

• Check that the watch is operating, and then set the time and date.
• The watch is provided with a date function and is designed so that the date changes
once every 24 hours. The date changes around 12 o'clock midnight. If AM/PM is
not properly set, the date will change around 12 o'clock noon.
1. Pull out the crown to the first click. (The small
second hand continues moving and the accuracy
of the watch is unimpaired.)
2. The date can be set by turning the crown
counterclockwise. Turn it until the previous day's
date appears.
Ex.) If today is the 6th of the month, first set the date
to "5" by turning the crown counterclockwise.
CAUTION
• Do not set the date between 8:00 p.m. and 2:00 a.m. If you do so, the date
may not change properly on the following day or malfunction of the watch
may occur.
9