Key Automation VIPER LED Instrucciones Y Advertencias Para Su Instalación Y Uso página 29

4.21 Memorisation and deletion of transmitters
Follow the procedure below to memorise ROLLING CODE transmitters. To memorise FIXED CODE transmitters, refer to point 4.12, then
memorise the transmitters as described below:
1) MEMORISING A REMOTE CONTROL
• Press and release the "S" button on the sectional operator a number of times equal to the number of the output to be activated: once for
output 1 (door command ), twice for output 2 (courtesy light).
• The "0" on the display of the sectional will flash a number of times equal to the number of the output selected, with 1 second pauses between
flashes
output 1:
output 2:
• Press the key of the remote control to be memorised within 7 seconds, holding it down for at least 2 seconds
• If the memorisation has been successful, the "0" on the display will give one long flash and 1 beep
• To memorise another remote control on the same output, repeat point 1
N.B. If no commands are given for 7 seconds, the sectional automatically quits the programming mode
BUZZER SIGNAL
1 beep
2 beeps
3 beeps
2) DELETING A REMOTE CONTROL
• Press the "S" button until the "0" on the display lights up (about 3 seconds)
3 sec
MEANING
code memorized
code already memorised
memory full
> 3 sec
EN
29