Key Automation VIPER LED Instrucciones Y Advertencias Para Su Instalación Y Uso página 30

EN
• Press the key of the remote control to be deleted within 7 seconds, holding it down until the "0" on the display goes out. Release the remote
control key
• About 1 second after the remote control key is released, the "0" on the display starts to flash
• Confirm the deletion by pressing and release the "S" button on the sectional
• If the deletion has been successful, the "0" on the display will give one long flash
N.B. If no commands are given for 7 seconds, the receiver automatically quits the programming mode
3) CLEARING THE ENTIRE RECEIVER MEMORY
• Press the "S" button on the sectional and hold it down until the "0" lights up (about 3 seconds) and then goes out (about 3 seconds). Re-
lease the "S" button
• About 1 second after the "S" button is released, the "0" on the display starts to flash
• Press and release the "S" button on the display as the "0" flashes for the third time
30
0,5 sec
3 sec
> 3 sec
1 sec
0,5 sec
> 3 sec
1 sec