ION Vinyl Transport Guia De Inicio Rapido página 3

Features
1. Platter – Place your record here.
2. 45 RPM Adapter Holder – Holds the
included 45 RPM adapter. When not using
the adapter, please place it in this holder.
3. Tonearm – The fixed tonearm can be raised
and lowered by hand, or by pressing the
raise / lower lever.
4. Arm Clip – This specially designed arm clip
secures the tonearm while at rest or when
not in use. The arm clip has been designed
to remain in the up position while unlocked.
5. Raise / Lower Lever – Raises and lowers
the tonearm.
6. 33 / 45 / 78 Switch – This switch controls
the RPM of the turntable platter.
Note: For best results when playing 78 RPM vinyl
records, use a 78 stylus (sold separately). Only use a 78
stylus with 78 RPM vinyl records. Purchase the iCT06rs
78 stylus at ionaudio.com/ict06rs.
7. Autostop switch – This switch turns autostop on or off.
When autostop is on, the platter will start spinning
when the tonearm is placed over the record and stop
spinning when the record has reached the end. (When
autostop is off, the platter will always spin regardless of
the position of the tonearm.)
Note: If your vinyl record stops before it reaches the
end of the music, turn Autostop to the off position for
this particular record. This is generally recommended
for 45 RPM records.
8. Volume/Power Knob – To power on Vinyl
Transport, turn this knob clockwise until it clicks.
When powered on, use this knob to adjust the
volume. To turn off Vinyl Transport, turn this knob
counterclockwise until it clicks.
9. Power Indicator – This LED illuminates when the
power is on.
10. Speaker – The record's audio will be played
through this built-in speaker.
11. RCA Output* – The audio from a playing vinyl record is sent to this line-level coaxial audio output. This
must not be connected to phono level devices.
12. Power Cable Input – Use the included adapter to connect to wall power.
1
10
IMPORTANT: Place the included felt slipmat
on the platter; then place your record on the
felt slipmat to carefully hold your records.
IMPORTANT: Remove the plastic cartridge
cover (needle cover) before operating the
turntable.
*WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your receiver
if you plug in a LINE level device into a
PHONO level input.
OUT
R L
11
3
2 3
5
4
6
33
45
78
7
9
AUTO
STOP
OFF
ON
POWER
8
MIN MAX
ON / OFF
10
DC 5V 1A
12