Maintenance; Maintenance Schedule; Product Specifications; Generator Specifications - Generac XG Professional Serie Manual De Usuario

Maintenance

Use battery charger plug to keep the battery charged and ready
for use. Battery charging should be done in a dry location.
1. Plug charger into "Battery Charger Input" jack, located on the
control panel. Plug wall receptacle end of the battery charger
into a 120 Volt AC wall outlet.
2. Unplug battery charger from wall outlet and control panel jack
when generator is going to be in use.
Do not use the battery charger for more than 48 hours at one
charge.
The switch must be in the RUN position. Use one of the
generator's receptacle outlets along with the included battery
charger to charge the battery while the generator is running.

3.1 MAINTENANCE SCHEDULE

Follow the calendar intervals. More frequent service is required
when operating in adverse conditions noted below.
Check Oil Level
Change Oil and Oil Filter‡
Clean Spark Arrestor Screen
Service Air Cleaner
Replace Spark Plug
‡ Change oil after first 30 hours of operation then every season.
* Change oil and oil filter every month when operating under heavy load
or in high temperatures. Clean more often under dirty or dusty operating
conditions. Replace air cleaner parts if very dirty.

3.2 PRODUCT SPECIFICATIONS

3.2.1 GENERATOR SPECIFICATIONS

Rated Max. Power .................................................................10.0 kW**
Surge Power .............................................................................12.5 kW
Rated AC Voltage ......................................................................120/240
Rated Max AC Load
Current @ 240V .............................................................41.7 Amps**
Current @ 120V .............................................................83.3 Amps**
Rated Frequency .................................................... 60 Hz @ 3600 RPM
Phase ................................................................................ Single Phase
Rated DC Voltage ...................................................................... 12 Volts
Battery Type .................................................................... 10 AH, 12VDC
** Maximum wattage and current are subject to, and limited by, such factors
as fuel Btu content, ambient temperature, altitude, engine condition, etc..
Maximum power decreases about 3.5% for each 1,000 feet above sea level;
and will also decrease about 1% for each 6° C (10° F) above 16° C (60° F)
ambient temperature.
12
NOTE:
NOTE:
At Each Use
*Every Season/Every 100 Hours
*Every Season/Every 100 Hours
*Every Season/Every 200 Hours
*Every Season/Every 200 Hours

3.2.2 ENGINE SPECIFICATIONS

Rated Horsepower @ 3600 RPM ................................................. 18 Hp
Displacement ............................................................................... 530cc
Spark Plug Type ........................................... NGK BPR6HS or Equivalent
Spark Plug Part No. ...................................................................0E9368
Spark Plug Gap ............................................... 0.030 inch or (0.76 mm)
Gasoline Capacity .......................................................... 10 U.S. gallons
Oil Type.................................... See Chart in "Adding Engine Oil" Section
Oil Capacity ................................................ w/ Filter Change = 1.8 Qts.
Run Time/Fuel Consumption-1/2 Load .. 10 Hours / .73 gallons per hour
Class II Emission Certified

3.2.3 EMISSIONS INFORMATION

The Environmental Protection Agency (EPA) and California Air
Resource Board (CARB) require that your generator comply with
exhaust and evaporative emission standards. This generator is
certified to meet the applicable EPA and CARB emission levels.
Additional information regarding the requirements set by EPA and
CARB is as follows:
It is important that you follow the maintenance specifications
provided in this manual to ensure that your engine complies with
the applicable emission standards for the duration of the engine's
life. This engine is certified to operate on gasoline. The emission
control system on your generator consists of the following:
• Fuel System
~ Fuel Tank
~ Fuel Cap
~ Carburetor
~ Fuel Lines
• Evaporative Control System
~ Carbon Canister
~ Vapor Hoses
The Emissions Compliance Period referred to on the Emissions
Compliance Label indicates the number of operating hours for
which the engine has been shown to meet Federal and California
emission requirements. See the table below to determine the
compliance period for your generator. The displacement of your
generator is listed on the Emissions Compliance Label.
Displacement Category
 66 cc - < 225 cc
 225 cc
w/o Filter Change = 1.5 Qts.
• Air Induction System
~ Intake pipe/manifold
~ Air cleaner
Ignition System
•
Spark plug
~
~ Ignition module
Exhaust System
•
Pulse Air Injection Valve
~
~ Muffler
Compliance Period
A 500 Hours
B 250 Hours
C 125 Hours
A 1000 Hours
B 500 Hours
C 250 Hours