Cleaning And Maintenance - Saivod HB1913 Manual De Instrucciones

Instruction for blender
1. To assemble the detachable shaft with the motor unit, turn the shaft anti-clockwise
direction until tightened. To disassemble, just turn in the adverse direction.
2. Simply plug the hand-held blender to power outlet.
3. Lower the hand-held blender into food.
4. Operation of the blender -Speed settings:
4.1 Press and hold the low speed button to start operating.
4.2 At the same time you can select desired speed setting by dialing the speed control
dial, there are five settings: 1, 2, 3, 4, 5 (from low speed to high speed).
4.3 You also can start operating by pressing and hold the high speed button (turbo
button), the appliance will operate at the highest speed all the time. The speed will
not change even if you dial the speed control dial.
4.4 To stop the hand-held blender by releasing the low speed button or high speed
button.
5. Operating times
Max operation duration per time cannot exceed 1 minute, and 3 minute rest time must be
maintained at two consecutive cycles.

CLEANING AND MAINTENANCE

1. Unplug the appliance and remove the detachable stem.
Note: Do not immerse the detachable stem of the blender in water because overtime the
lubrication on the bearings may wash away.
2. Wash the detachable stem under running water, without the use of abrasive cleaner or
detergents. After finishing cleaning the detachable stem, place it upright so that any water
which may have got in, can drain out. The stem is dishwashing safe component.
3. Wipe the motor unit with a damp cloth. Never immerse it in water for cleaning as a
electric shock may occur.
4. Dry thoroughly.
Caution: Blades are very sharp, handle with care.
Quick cleaning
Between processing tasks, hold the hand-held blender in the cup half filled with water and
turn on for a few seconds.
When the time comes to eliminate this product, please consider the environmental impact
and take it to recognised recycling facility instead of disposing it with general household
waste. Take the equipment to a waste disposal site. Plastic and metal parts that are used in
the construction of this appliance can be separated into pure grade which allow recycling.
Ask to your service centre for details. Everyone of us can participate on the environmental
protection.
18