Complete The Installation - Kohler K-3487 Manual Del Usuario

Compression
Washer
Fill Valve
Nut
Supply Shank
Compression
Seal
Nut
Washer
Ferrule
Coupling
Nut
Supply
Shut-Off
Valve
Supply Shut-Off Valve
Connection

4. Complete the Installation

Install the trip lever if one is not already installed. Follow the
instructions packed with the trip lever.
Connect the supply shut-off valve to the toilet supply shank.
Open the supply shut-off valve slowly to check for leaks. If the
connections have been properly assembled, a slight tightening of
the nuts should stop leakage.
Install the toilet seat according to the packed instructions.
Carefully set the cover onto the tank.
Flush the toilet several times and check all connections for leaks.
Periodically check for leaks for several days following the
installation.
Adjustments
NOTE: The flush volume may be adjusted to 1.6 gallons (6 L) per
flush or 1.4 gallons (5.3 L) per flush by adjusting the water level in
the tank.
Adjust the water level in the tank to the waterline by squeezing
and sliding the C-clip on the float rod.
• To raise the water level, slide the C-clip up.
• To lower the water level, slide the C-clip down.
1020805-2-D
Tubing
C-Clip
6
1.6 gpf (6 L)
Waterline
1.4 gpf
(5.3 L)
Kohler Co.