Installing The Light Kit And Glass Shade - Hinkley TIER 54" Manual De Instrucciones

INSTALLING THE LIGHT KIT AND GLASS SHADE

NOTE: Be sure the power is off before installing.
Remove one of the three screws on the mounting plate
1
located on the fan motor. Loosen the other 2 screws. (Do not
remove) (Fig. 2)
While holding the LED light kit under your fan, make the
2
polarized plug connections: (Fig. 2)
- Red to white
- Black to black
Tuck connections neatly into mounting plate. Place the key
3
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws previously
loosened and the one previously removed.
4 Raise the glass shade against the LED light kit and turn
clockwise until snug, DO NOT OVERTIGHTEN.
5
Restore power and your light kit is ready for operation.
12 | hinkley.com
Wire connectors
Light Kit
Glass shade
Fig. 2
5
Screws