Installing The Led Assembly And Glass Shade - Hinkley 99 INDY MAXX Manual Del Usuario

INSTALLING THE LED ASSEMBLY AND GLASS SHADE

NOTE: Be sure the power is off before installing.
Remove one of the three screws on the adapter plate located
1
on the fan motor. Loosen the other 2 screws. (Do not remove)
(Fig. 3)
While holding the LED assembly under your fan, make the
2
polarized plug connections: (Fig. 3)
- Red to white
- Black to black
Tuck connections neatly into adapter plate. Place the key
3
holes on the LED assembly over the 2 screws previously
loosened, turn the LED assembly until it locks in place at the
narrow section of the key holes. Secure by tightening the 2
screws previously loosened and the one previously removed.
4 Raise the glass shade against the LED assembly and turn
clockwise until snug, DO NOT OVERTIGHTEN.
5
Restore power and your LED assembly is ready for operation.
12 | hinkley.com
Wire connectors
Light
assembly
Glass Shade
Fig. 3
Screws