3. Launch the "BVCAM" APP again. If the camera shows "Online" on the "Live video" page,
it means the remote view setup is successful and the camera has entered into WAN mode.
Both blue and red indicator lights will be illuminated. You can go ahead to view live video or
record video remotely.
[Note]:
If the camera shows "Device Offline", it means the remote view setup failed and you need to
reset the camera (See VIII) and set up all over again.
V. Motion Detection Recording Setup
>> Please make sure that the camera is added to the APP in LAN or WAN mode and it's
online before you start.
5.1. Launch the "BVCAM" APP.
5.2. Set up motion detection photograph as below:
Step1: Tap the setting icon on the "Live video" page then choose "Advance Config" or
"Device Settings".
Step 2: Go to "Alarm Config" page, there, you can set a desired alarm sensitivity level, alarm
schedule, and alarm interval time. Enabling the "Warning Tone", "Push Notification" and
"On-screen Display" is also available.
Step 3: Tap "OK" to complete the setting.