Bu Lb R E Plac Em Ent; Clea Ning The L Ens - Char-Broil 463277519 Guía Del Producto

G RI LL LIG HTS - OPE RATION AN D BU LB RE PLACE M E NT
Ligh t Operatio n
•
If your grill is hot, make sure the grill has been turned OFF and allowed to cool.
•
Ensure the Grill Light Switch is in the OFF position.
•
Connect the light plug to an extension cord, then put the extension cord plug into the wall
receptacle.
•
Turn the light switch ON

Bu lb R e plac em ent

•
Make sure light switch on the control panel is in the OFF position and adapter plug is
disconnected from outlet.
1 .
Release the screw securing the light socket.
2 .
Take out the socket and remove the lens.
3 .
Loosen the two screws which are locking the bulb. NOTE: Skip step 3 if there is no screw
locking the bulb.
4 .
Pull out the old bulb.
5 .
Before handling the new bulb, put on a pair of cotton gloves. The oils from your hands can
damage or shorten the life of your new bulb.
6 .
Install the new bulb.
7 .
Reverse instructions from step 3 through step 1 to re-install socket.

Clea ning the L ens

1. Prior to cleaning, make sure grill has been turned off, cooled, and the light switch is in the
"OFF" position and the light plug is disconnected from the power supply.
2. Do not clean the glass lens when warm. Allow to cool before cleaning. Sudden change in
temperature may cause cracking of the glass lens.
3. Use a damp towel to clean the surface of the glass lens.
4. Allow the lens to dry before reconnecting the light plug to the power supply and turning the
light switch to the "ON" position.
W A R N I N G
•
Keep any electrical supply cord away from any heated surface.
•
Use the shortest length extension cord required. Do not connect 2 or more extension cords
together.
•
To protect against electric shock, do not immerse cord or plugs in water or other liquid.
•
Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on
or taking off parts.
•
Do not operate grill with a damaged cord, plug, or after the appliance malfunctions or has
been damaged in any manner.
•
Do not let the cord hang over the edge of a table or touch hot surfaces.
•
Do not use an outdoor cooking gas appliance for purposes other than
•
When connecting, first connect plug to the outdoor cooking gas appliance then plug
appliance into the outlet.
•
Use only a Ground Fault Interrupter(GFI) protected circuit with this outdoor cooking gas
appliance.
•
Never remove the grounding plug or use with an adapter of 2 prongs.
•
Use only extension cords with a 3 prong grounding plug, rated for the power of the equip-
ment, and approved for outdoor use with a W-A marking.
1
2
3
Loosen the two screws which
are locking the bulb, if needed.
4
i nt e nde d.
Bulb Specification
B u l b Typ e:
Watt age :
Vol t ag e:
Pa ge 11
H al oge n
10 Watt s p er bu l b
12 V
C H A R B R O I L. C O M