Whale GP1002 Instrucciones De Instalación Y Usuario página 3

Fig. A
Whale
faucets
Check
valve
Whale
Babyfoot
pump
1 2
Self-venting submersible pump
Notes:
* Do not run the pump dry
* Do not use the pump in water temperature above 40°C (100°F)
7. MAINTENANCE
• Submersible pump strainers should be inspected and cleaned at frequent intervals to ensure the water supply is free of debris especially from tanks will reduce the
likelihood of pump clog. The pumps are sealed units and do not require further maintenance.
• Winterizing: To protect against damage as a result of freezing, drain the entire water system.
8. HELPFUL HINTS
• For Submersibles - Before switching on, place the pump in water and shake for a few seconds to release trapped air. This will ensure successful priming and should be
repeated when the water tank is refi lled.
• For the Whale In-Line Booster pump - Before switching on check that there is water in the tank and that the system has been primed.
• Check that all hose connections are secure and airtight.
• Check that the power supply is at 12 or 24 volts depending on the model. Reduced voltage (i.e. a weak battery) or wire of a thickness of less than AWG #16 may
produce a voltage drop along the cable and reduced performance.
• Ensure that there is adequate ventilation in the water tank to prevent a vacuum building up, causing restricted water fl ow. Any tank or cap fi tting must have a
ventilation hole of at least 3 / " (5mm) diameter.
16
• Check that the pump's polarity is correct i.e. brown to '+' and blue to '-'.
• Store in a clean dry place at ambient temperature when not in use.
9. SERVICE SUPPORT DETAILS
For installation or serviceable parts advice, please contact Whale Support:-
10. EU DECLARATION OF CONFORMITY
Description of Equipment: Standard, Premium and High Flow pumps
We hereby declare, under our sole responsibility, that the above equipment complies with the provisions of the following EC Directives.
Electromagnetic Compatibility Directive 2004/108/EC.
CE mark affi xed: 20/9/06
Basis on which conformity is declared
The above equipment complies with the protection requirements of the EMC Directive.
Standards applied
EN60335-1:2002 Safety of household and similar electrical appliances.
EN60335-2-41:2003 Particular requirements for pumps.
EN55014-1:2006 & A1:2009 Electromagnetic compatibility. Requirements for household appliances, electric tools and similar apparatus.
Emission.EN55014-1:2006
EN55022:2006 & A1:2007 Information Technology Equipment: Radio disturbance characteristics - limits and methods of measurement.
Signed (Authorised person)
Richard Bovill
Engineering Director
11. WARRANTY
©Copyright Whale 2017 - All rights reserved. Reproduction in whole or in part without permission is prohibited. WHALE®, is a registered trademark of Munster Simms
Engineering Limited, Bangor, Northern Ireland trading as Whale. Whale's policy is one of continuous improvement and we reserve the right to change specifi cations
without prior notice. Illustrations are for guidance purposes only. Neither the accuracy nor completeness of the information contained in any Product brochure is
guaranteed by the Company and may be subject to change at its sole discretion. Please note that by contacting Whale Support you will be indicating your consent to
receiving product updates, recall information, help guides and appropriate marketing messages from us via post, email or telephone unless you indicated an objection to
receiving such messages.
Munster Simms Engineering Ltd (Whale)
2 Enterprise Road, Bangor, Co Down, N. Ireland BT19 7TA
Tel: +44 (0)28 9127 0531 Web: www.whalepumps.com Email: info@whalepumps.com
Whale
Elegance
tap
Aquasource
Heater
clear water
fi lter
Whale
in-line
pressure
3 4
Fig. B
Whale
Whale
Elegance
Elegance
tap
tap
1 2
Aquasource
clear in-line
water fi lter
Whale
Babyfoot
pump
Whale
Gusher
Galley
pump
In-line booster pump
Tel: +44 (0)28 9127 0531 Email info@whalepumps.com
USA Support Tel: +1 616 897 9241 Email usasales@whalepumps.com
Web: www.whalepumps.com
3
Whale hand
pump
Whale
faucet
3 4 5
Heater
In-line
Check
pressure
valve
switch
Check
valve
Ref: 181.01_v8_0417_db
Water
supply