Scope Of Application; Start-Up - First Use - Hozelock 4192 Green Power XL Manual Del Usuario

or near flammable materials.
Do not use in an arid zone to prevent risks
of fire.
Do not direct the hot air towards persons
or animals.
Do not direct the hot air flow to the same
point for a rather long period.
Ensure the heat cannot propagate to
hidden flammable materials, and ignite
them.
After its use, lay the GREEN POWER XL on
its carrier (Fig1 item 7) safely and leave it
to cool down completely before storing it.
Do not leave the GREEN POWER XL
running unattended.
Do not expose the GREEN POWER XL to
rain or humidity.
Do not immerse the GREEN POWER XL
in water.
Disconnect the device before changing
any accessories or storing it.
Do not touch the hot nozzle (Fig1 item 8,9).
Never obstruct the vents (Fig1 item 5).

SCOPE OF APPLICATION

The GREEN POWER XL is designed for a
private domestic use.
It eliminates weed by means of thermal shock. The fast
temperature build-up bursts the cells of the plant and destroys
the weed.
START-UP – FIRST USE
Starting up
Choose the round nozzle or the extra large nozzle for your
using.
Nozzle
treatment in the
Round lawn, vegetable
Treatment of the
paths, pavement,
Extra large
Duration of
Using the treatment
per plant
Localized
3-5 secondes
garden,
flowerbeds...
5-7 secondes
gravel path,
borders...
Assemble without tool the nozzle chosen with bayonet system
(Fig3).
Caution: Don't exchange, don't
dismount or don't assemble a nozzle
if GREEN POWER XL was just used.
Make sure that the product is totally cold
before to do these operations.
Ensure the nozzle (8 or 9) is properly
fitted and the switch (4) is set to 'OFF'
(Fig2A). Connect the GREEN POWER XL
with the supply cable (3) onto the power
supply network after checking the safety
measures are observed.
Check that nothing is placed in front of
the nozzle when switching on the GREEN
POWER XL.
Start the GREEN POWER XL by setting
the switch to the 'heating' position (Fig2B).
Hold the GREEN POWER XL with its
ergonomic handle (1).
Warm up the device for 45 seconds to
reach the operating temperature.
To eliminate weed, apply the nozzle (8
or 9) onto it while letting it rest on the
ground for the duration indicated in the
table above. You simply need to heat
(whiten) the weeds until they shrink back;
there is no need to burn the plant.
The plant cells will then dry and the weeds
will wither and be destroyed in 2 to 3 days.
The residue may then be removed and
composted.
Note: several
necessary for stubborn and tenacious
weeds.
Stopping the device
Before stopping the device completely, a
cooling phase is required.
Set the switch (4) to the "Ventilation"
position (Fig2C). Ventilation must last 30
seconds minimum.
Once this operation is complete, you can
set the switch to OFF (Fig2A) to switch off
the GREEN POWER XL.
treatments may be