Print Setups; Setting The Baud Rate - SOLVO VALLÉS FH Serie Manual De Utilización

Firmware Version
CAL T
ambient temperature
compensation
ESC: Exit

PRINT SETUPS

There are three print types:
STABLE Print: print a stable reading when it is attained.
INSTANT Print: print immediately after press the Print key.
INTERVAL Print: print at predeterminated time intervals.
Notice:
The print function is separate from the line feed setup, i.e set the print function first then set the
number of line feeds.
To set the print type, use the following procedure:
1. Press the
2. Press the
default.
3. Press the
4. Press the
"SEC".
5. Press the
confirm. The message "0 SEC" means countinous print.
6. Press the
7. After entering print setup, press the
(1-18) Choose the proper line feeds, press the

SETTING THE BAUD RATE

1. Press the
2. Press the
3. Press the
4. Press the
FACT TP: restore factory setups
uSEr TP:
user temperature compensation
ESC: exit program
key while pressing the
key, the display will show "STAbLE", which indicates stable print as the
key to choose the print type and confirm pressing the
key until the display reads "InTEr", press the
key repeatedly to see the predeterminated time interval and press the
key to return to weighing mode.
key while pressing the
key, the balance reads "bAud"
key, the balance reads "300"
key repeatedly, the balance display the other baud rates. Choose the proper
key, the display will show "PrInt"
key repeatedly to see predetermined line foods
to return to normal weighing mode.
key, the display will show "PrInT"
key, the display will show
to
13