Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe 31815000 Manual De Instrucciones

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal pres-
sures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 33)
To adjust the hot water limiter. Using a hot
water limiter in combination with a continu-
ous flow water heater is not recommended.
4
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
65°C
max. 70°C / 4 min
Assembly (see page 31)
English
Dimensions (see page 34)
Flow diagram (see page 34)


Operation (see page 35)
• Do not rotate the spout further than 360º
• Hansgrohe recommends not to use as
Cleaning (see page 37)
Maintenance (see page 37)
The check valves must be checked regularly
according to DIN EN 1717 in accordance
with national or regional regulations (at least
once a year).
Spare parts (see page 38)
XXX = Colors
000 = Chrome Plated
800 = Stainless Steel Optic
Test certificate (see page 40)
with EcoSmart
®
without EcoSmart
®
or damage to the hose will result.
drinking water the first half liter of water
drawn in the morning or after a pro-
longed period of non-use.