Publicidad
The interlock system is a safety feature that prevents more than one drawer from opening at the
same time. Do not use excessive force to open the drawers.
3
3
Be sure the
interlock track
snaps into each
safety stop.
5.
Diagram 1. Measure 1-1/2" from one end of the INTERLOCK TRACK (21G). Position the INTERLOCK TRACK as shown.
SAFETY STOP / TRACK ATTACHMENT:
Diagram 2. Tilt the first edge of the INTERLOCK TRACK (21G) into the SAFETY STOP (29G).
Diagram 3. Rotate the INTERLOCK TRACK and apply force to snap the second edge into the SAFETY STOP.
Diagram 4. Repeat the SAFETY STOP / TRACK ATTACHMENT for the next SAFETY STOP while holding the previously
completed SAFETY STOP in its location hole. Repeat these steps until all SAFETY STOPS have been attached. Visually check that
all INTERLOCK TRACK edges have been snapped into the SAFETY STOPS as shown in diagram 3.
Diagram 5. Remove the INTERLOCK TRACK assembly from Diagram 4 and flip it over before inserting the INTERLOCK
TRACK (21G) with SAFETY STOPS (29G) into the groove in the RIGHT END (A).
415978
21G
2.
29G
A
29G
21G
A
www.sauder.com/services
3.
21G
29G
4.
1.
Page 7
Publicidad
