Publicidad
4
4
Push the black lever in and pull the SLIDE from the RAIL.
I
Open end
Separate the EXTENSION SLIDES (J) from the EXTENSION RAILS (I) as shown in the upper diagram. Be prepared, the parts are
greasy.
Fasten four EXTENSION RAILS (I) to each END (A and B). Use sixteen GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Page 8
J
29G
I
I
Finished edge
After fastening the EXTENSION RAILS to the RIGHT END (A),
the SAFETY STOP should touch the top edge of the RAILS. If
the gap is larger than 1/16", the drawers could lock up and not
open. If this happens, open two drawers at the same time to
override the interlock system. Remove the drawers to re-adjust the
INTERLOCK TRACK assembly.
www.sauder.com/services
I
Finished edge
I
21G
I
A
B
I
GOLD 5/16" FLAT HEAD SCREW
(16 used in this step)
3S
Open end
I
29G
I
I
415978
Publicidad
