Festool TS 75 EQ Manual De Instrucciones Original página 14

English
Never position large or long workpieces so that
they bend in the middle or at the cutting face.
This can lead to the saw blade jamming and re­
coiling. Instead, support the workpiece with
several wooden battens [12.2], particularly in
the vicinity of the cutting face.
9.3 Sawing
The machine must reach full
speed before cutting begins and should only be
switched off once cutting has finished.
Only operate the saw away from
you (pushing the circular saw forwards, [13.3])
and never towards you (pulling the circular saw
backwards). If you saw towards you, there is the
danger that the circular saw might be acceler­
ated out of the cutting groove (recoil) and cause
serious injury.).
13.1 13.2
A) Sawing sections
► Place the front part of the saw bench on the
workpiece. The cutting indicator [13.2] dis­
plays the cutting line for 0° and 45° cuts
(without guide rail).
► Switch the machine on, and press the saw
down to the set cutting depth.
► Push the machine in the direction of cut.
Take care that the saw bench remains firm­
ly on the workpiece.
► Switch the machine off when cutting is com­
pleted.
14
B) Plunge cuts
following in structions absolutely must be ob­
served when plunge cutting:
14.1 14.2
12.2
–
–
–
Procedure
► Place the machine onto the workpiece and
► Switch the machine on.
► Slowly press it down onto the set cutting
The markings [13.1] display the absolute front
and the absolute rear cutting points of the saw
13.3
blade (dia. 8-1/4" (210 mm)) at maximum cut­
ting depth and using the guide rail.
In order to avoid kickbacks, the
The machine must always be placed with
the rear edge of the saw table against a
fixed stop.
When working with the guide rail, the tool
must be placed at the kickback stop [14.2],
which is firmly clamped on the guard rail.
When not in use, the kickback stop can be
kept in safe keeping at the guide
plate [14.1] of the machine.
The machine must always be held securely
with both hands and only plunged slowly.
position it against a stop (kickback stop).
depth and push it forward in the cutting di­
rection.