Stanley Smart Measure Pro Manual Del Usuario página 5

Industry Canada. To reduce potential radio
interference to other users, the antenna type
and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.)
is not more than that necessary for successful
communication.
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to
OET65 and RSS-102 of the IC radio frequency
(RF) Exposure rules. This equipment has very low
levels of RF energy that are deemed to comply
without testing of specific absorption ratio (SAR).
This product is intended to be powered by a UL
Listed power supply; output rated 5 Vdc, 0.35 A.
The laser product complies with the requirements
set forth in UN Manual ST/SG/AC.10/11/Rev.5/
part III, Subsection 38.3. Shipping of Li Ion battery
powered products is regulated therefore you
should consult with your carrier prior to shipping
Li Ion Battery powered product.
End of Life
DO NOT dispose of this product with household
waste.
PLEASE RECYCLE in line with local provisions
for the collection and disposal of electrical and
electronic waste.
Declaration of Conformity
This product conforms with IEC60825:2014.
Maintenance and Care
DO NOT allow to get wet. Damage to internal
circuits may result. Laser tool is not waterproof.
DO NOT leave laser tool in direct sunlight or
expose it to high temperatures. The housing and
some internal parts are polymeric materials and
may become deformed at high temperatures.
DO NOT store the laser tool in a cold
environment. Moisture may form on interior parts
when warming up. This moisture could fog up
laser windows and / or cause corrosion of internal
circuit boards.
NOTE: When working in dusty locations, some
dirt may collect on the laser window. Remove any
moisture or dirt with a soft, dry cloth.
DO NOT use aggressive cleaning agents or
solvents.
Charging Your Smart Measure Pro
Your Smart Measure Pro has an internal, non-
removable, rechargeable battery. Do not attempt
to remove the battery from the device as you
may damage the device. To charge the unit,
connect the USB charging cable into the micro
USB charging port on the unit and then plug it in
to an appropriate USB port. Longest life and best
performance can be obtained if the battery pack
is charged when the air temperature is between
18° and 24 °C (65 °F –75 °F). DO NOT charge the
battery pack in an air temperature below +4.5 °C
(+40 °F), or above +40.5 °C (+105 °F ). This is
important and will prevent serious damage to the
battery pack. NOTE: While the unit is charging,
the LED indicator will flash green. When charging
is complete, the LED indicator will be solid green.
The Bluetooth® device will fully recharge in
4 hours or less.
5