Axxess AX-HUB Instrucciones De Instalación página 2

Updating Axxess Interface
Depending on which Axxess interface you are updating, the correct update cable
will need to be used (both cables are provided).
(A) If updating an interface with a 4-pin Bootloader connector:
Note: Interfaces with the 4-pin Bootloader connector do not need power to the
interface to be updated.
• Connect the 4-pin to 4-pin Bootloader update cable supplied, into the 4-pin
port next to the DC power port.
• Open the application and then press the "Update Firmware" button.
• Connect the opposite end of the Bootloader cable into the interface that is to
be updated. The new software will download to the interface at this time.
(B) If updating an interface with a Micro "B" USB connector:
Note: Interfaces with a Micro "B" USB connector need power to the interface
to be updated.
• Begin by turning the vehicles ignition on, which will then power the interface.
• Connect the Micro "B" USB update cable supplied, into the interface being updated.
• Connect the opposite side of the cable into the USB port on the LEFT side of
the AX-HUB (port with USB symbol).
• Open the App, and press the "Update Firmware" button. The new software will
download to the interface at this time.
For both applications one of the two situations will occur, depending on your
mobile device: While the interface is updating, either a process indicator bar, or
the app will inform you that the interface is up to date, and then supply with which
firmware it downloaded to your interface. The app will also give you the option to
perform a "Force Update".
Axxess Integrate
Installation instructions for AX-HUB
axxessinterfaces.com
Note: Please note which firmware downloaded to the interface. This will help in
troubleshooting, if need be.
Assigning functions to the ASWC-1
Attention: The ASWC-1 must first be programmed to the vehicle
before performing this step.
• Apply power to the ASWC-1.
• Connect the micro "B" USB update cable supplied, into the ASWC-1.
• Connect the opposite side of the cable into the USB port on the LEFT side of the
AX-HUB (port with USB symbol).
• From within the Axxess Updater app, press "SWC Settings".
• Select the preferred feature(s) you would like to have changed, and then press
"Connect to ASWC". The new features will then download to the ASWC-1.
IMPORTANT
If you are having difficulties with the installation of this product, please call our Tech
Support line at 1-800-253-TECH. Before doing so, look over the instructions a second
time, and make sure the installation was performed exactly as the instructions are
stated. Please have the vehicle apart and ready
to perform troubleshooting steps before calling.
ATTENTION:
Scan here for the App or visit
http://axxessinterfaces.com
•
metraonline.com
Metra recommends MECP
certified technicians
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
P
OWER